Creative candle design: individual decorations for your home
Decorated candles with the Candle Liner
Preparing the mould: Apply some of the mixture directly from the Candle Liner to your silicone mould. Use a spatula to spread the mixture firmly and evenly in the mould.
Time to dry: Leave the figure to dry for around 6-7 hours. You can then carefully remove it from the mould. Repeat this process as often as you like.
Labelling or painting: Decorate your candle by writing or painting directly on it with the candle liner. If you make a mistake, you can wipe it off with a cloth and start again. Allow the writing or motif to dry thoroughly.
Attach the figures: Coat the small figures with Candle Liner glue and press them firmly onto the candle to achieve a permanent result.
Elegant stick candle holder made from Keraflott
Cut out the circle: Cut a circle with a diameter of 7 cm from the pinwheel foil and place it in the centre of the casting mould. This creates a candle holder for a pillar candle.
Keraflott mixture: Mix about 4 heaped tablespoons of Keraflott with water to make a creamy mixture. Pour this into the mould and tap it gently on a firm surface to ensure even distribution and avoid air bubbles.
Demoulding: After an hour, remove the casting from the mould and remove the pinwheel foil circle. Allow the holder to dry completely to achieve optimum strength. Smooth any rough edges with sandpaper.
Composition: Pour some coloured sand into the candle holder bowl and place a pillar candle on top.