Natural crepe paper dandelion
Anleitung No. 375Fold a 6 cm wide crepe strip (approx. 30 cm long) lengthwise for each flower. Cut a 2 cm deep incision on the open side every 2 - 3 mm. Offer the fringes approx. 20 cm far over a pin to the outside.
Cut the wire for the flower stalk. Cover the first 2 cm of the frosted crepe paper completely with Handicraft glue and place the wire on top. Fold the end of the strip over and wrap it as tightly as possible around the wire. For the flower attachment, cut an 8 x 3 cm strip of green Crêpepaper on one long side 8 times to the middle. Screw in the resulting strips and stick them under the flower.
Cut an 8 - 10 mm wide strip on one side of the Crêpepaper roll. Coat one end of the strip with Handicraft glue and place it as close as possible under the flower. Turn the flower stem with one hand so that the Paper strips is wrapped around it at an angle. Fix the end with Handicraft glue , cut off the remaining Paper .
Fold 4 x 18 cm green Crêpepaper lengthwise per sheet. Place the template on the folding edge, transfer and cut out. Wrap 1 cm wide green Crêpepaper around the support wire for the rib of the leaf and glue it in the middle of the leaf. To do this, apply a drop of Handicraft glue , draw a line with a stick and press the support wire firmly.
Paint the flower pots with Handicraft paint and stick the checked ribbon with tape-Ribbon around the edge. Then fill it with sticky paste and arrange the flower stems in it. Cover the surface with some moss.