www.vbs-hobby.com 
Exclusive offersAnleitung für farbenfrohe Windmühlen
Instructions No. 1316 Instructions No. 1316 Difficulty: Beginner
The self-made windmills bring colour and good mood in garden and children's room!
Here'show it works
For the tinkering of the windmills Rainbow-Craft cardboard sheet, a beech round barand Pins or pin needles and some binding wire is needed. For a windmill we used a rod of about 50 cm. The rod at VBS available beech round bar is 1 m long. So simply divide it in the middle and you have wooden rods for two windmills.
For the tinkering of the windmills Rainbow-Craft cardboard sheet, a beech round barand Pins or pin needles and some binding wire is needed. For a windmill we used a rod of about 50 cm. The rod at VBS available beech round bar is 1 m long. So simply divide it in the middle and you have wooden rods for two windmills.
From Rainbow-Craft cardboard sheet, one square per wind turbine is cut out, 22 x 22 cm in size. Using a ruler, draw two lines across the square from corner to corner so that the centre of the paper is marked precisely. Using the lines drawn, cut Lace to within 2.5 cm of the centre.
For the middle, cut out a paper circle with approx. Ø 3 cm and pierce it in the middle with a needle, leave it pierced on the needle.
Now, one after the other, pierce the left tip from behind with the needle, leaving it pierced on the needle. Little by little the wind wheel is created in this way. It is pressed with all four wings into the round bar. Finally some wire should be wrapped around the needle and round rod for further fixing.
